Page 1 of 1

Factory plates damage setting

Posted: Tue 29 Jan 2013 4:22 am
by gec100
hi 4Shades

Is there a option where i could change how tough the factory plates are?

let say if 250kg bomb hits the small plate in the center, how much damage does it make and could i change that?

thx

gec

Posted: Tue 29 Jan 2013 7:58 am
by IV/JG7_4Shades
That is hard-coded in the HSFX java. SEOW cannot control that.

Cheers,
4S

Posted: Tue 29 Jan 2013 8:30 am
by Classic_EAF19
I had similiar questions regarding the factory plates, perhaps a reader here may know thr answer. Why does a single bomb do different damage levels to factory plates? I can only assume that their is either a random factor or damage is calculated based on how close the bomb impacts the centre of the plate

Posted: Tue 29 Jan 2013 9:23 am
by 22GCT_Gross
after IL-2 release 4.11, bomb damage has been strongly randomized, as you observed.
Before that, IIRC, for destroying a small factory plate a flight of 4xB-24 with full bombload (all hitting the target) was needed.

Posted: Tue 29 Jan 2013 9:31 am
by gec100
what i learned so far is that it is very important how close to the center the bomb hits. i'm even quite sure i've read something about that somewhere.

i've found a section in the ships.ini

Code: Select all

// Factory Durability
[strength_Factory]
MinShotCaliber    0.203
NumShots          148
MinHitExplTNT     80
NumHitExpl        20
MinNearExplTNT    90
NumNearExpl       22

[strength_FactorySmall]
MinShotCaliber    0.203
NumShots          100
MinHitExplTNT     35
NumHitExpl        180
MinNearExplTNT    200
NumNearExpl       80

[strength_FactoryMedium]
MinShotCaliber    0.203
NumShots          180
MinHitExplTNT     45
NumHitExpl        190
MinNearExplTNT    200
NumNearExpl       100

[strength_FactoryLarge]
MinShotCaliber    0.203
NumShots          180
MinHitExplTNT     50
NumHitExpl        280
MinNearExplTNT    200
NumNearExpl       120
but i'm not sure what the settings do. i'll thy to play with it a bit and see what happens

i'd like to see damage in the percentage in the way seow shows it. how can i calculate the hits and damage from eventlog to get those percentages?

Posted: Tue 29 Jan 2013 10:15 am
by IV/JG7_4Shades
The eventlog shows all the information you need to do those calculations - that's why we wrote the eventlog record that way! Some format information is given in the Wiki.

These factory plates are defined in the ship class of IL-2, so they use the same damage logging code. I think the damage fraction reported in the eventlog record is cumulative, so it should always be increasing for successive damage events.

Cheers,
4S

Posted: Tue 29 Jan 2013 10:24 am
by gec100
thx shades. i've put mi question bad, but found the answer in the wiki.

do u have any knowledge about the settings in the ships.ini?

can changing them change the durability of the plates?

Posted: Tue 29 Jan 2013 6:55 pm
by IV/JG7_4Shades
I can't remember exactly, but I think that you can probably alter strength settings using ships.ini.