Supply Point config Problems
Posted: Thu 25 Oct 2018 2:15 pm
Greetings , All
I am having difficulty configuring an Air Supply Point .
I successfully created the SP I wanted in the correct location , correct alignment etc.
I deleted the SPs I was not going to use.
When I go into the Admin console I select 1 x C47 available at 0 delay.
My MP does not load correctly after this.
In the SEDB I examined the Resupply Replacements Table in the DB.
The Unit Name field is blank.
I assume the Unit Name field must have a value , and that is the error.
I make sure the historical date restriction is unchecked.
I select a British Transport Regiment name with no Campaign Sector Affilitations.
No luck.
I try the Verbose Unit Name.
No luck.
I add the Campaign Sector name for my Campaign to the Regiment Name in the Airforce Units Table and retry the Regiment Name.
No Luck.
I try the Verbose Unit Name with the Campaign Sector Filled in .
No Luck.
I replace my table , containing only one Supply Point and One Withdraw Point with the
original table from a default DB.
SEMP loads.
I change one of the existant Supply Points to Air Supply ( all were Ship Supply/Withdraw on this map)
and add a suitable altitude.
I go into the Admin function and again select a single C-47 available immediately.
SEMP will not load.
I examine the new Resupply Replacements Table.
There are 2 lines.
One is the line pertinent to the C-47 ( no Regiement affiliation) and one line is all blanks.
I delete the line with all blank fields.
SEMP still does not load.
I clear the values from all the fields in the remaining line.
SEMP loads.
I am at a loss.
Any assistance appreciated.
Kopfdorfer
I am having difficulty configuring an Air Supply Point .
I successfully created the SP I wanted in the correct location , correct alignment etc.
I deleted the SPs I was not going to use.
When I go into the Admin console I select 1 x C47 available at 0 delay.
My MP does not load correctly after this.
In the SEDB I examined the Resupply Replacements Table in the DB.
The Unit Name field is blank.
I assume the Unit Name field must have a value , and that is the error.
I make sure the historical date restriction is unchecked.
I select a British Transport Regiment name with no Campaign Sector Affilitations.
No luck.
I try the Verbose Unit Name.
No luck.
I add the Campaign Sector name for my Campaign to the Regiment Name in the Airforce Units Table and retry the Regiment Name.
No Luck.
I try the Verbose Unit Name with the Campaign Sector Filled in .
No Luck.
I replace my table , containing only one Supply Point and One Withdraw Point with the
original table from a default DB.
SEMP loads.
I change one of the existant Supply Points to Air Supply ( all were Ship Supply/Withdraw on this map)
and add a suitable altitude.
I go into the Admin function and again select a single C-47 available immediately.
SEMP will not load.
I examine the new Resupply Replacements Table.
There are 2 lines.
One is the line pertinent to the C-47 ( no Regiement affiliation) and one line is all blanks.
I delete the line with all blank fields.
SEMP still does not load.
I clear the values from all the fields in the remaining line.
SEMP loads.
I am at a loss.
Any assistance appreciated.
Kopfdorfer