Luny now a Syldavian

For all you devotees of this campaign based on Hergé's classic story.
Post Reply
WTE_Ikey
Posts: 920
Joined: Sat Feb 16, 2008 6:22 pm
Location: Wandering, Western Australia

Luny now a Syldavian

Post by WTE_Ikey » Mon Sep 17, 2012 7:05 am

Welcome Luny to Pelican campaign & a big thank you for his offer to assist with Syldavian planning.

Should see more regularity in these missions from now on.

Pls grant him access to red bunker.

Thenks
WTE_Ikey
The Chimpmeister
Bogan Gamer
LW/JG10_Luny
Posts: 743
Joined: Thu Feb 07, 2008 11:16 am
Location: Canary Islands

Post by LW/JG10_Luny » Mon Sep 17, 2012 7:14 am

Thank you Ikey.
IV/JG7_4Shades
Posts: 2029
Joined: Sat Jan 26, 2008 3:07 am
Location: Perth, Western Australia

Post by IV/JG7_4Shades » Mon Sep 17, 2012 7:19 am

Done, welcome Luny.
IV/JG7_4Shades
SEOW Developer
LW/JG10_Luny
Posts: 743
Joined: Thu Feb 07, 2008 11:16 am
Location: Canary Islands

Post by LW/JG10_Luny » Mon Sep 17, 2012 9:46 am

Thnaks.

Trying to look at the MP, I can enter using the propper pass, but once I try to look the whole sector or any of the sub sectors, airfields, cities or whatever, the browser stops at a blank page with the upper left corner message about gathering information and so on....

This same browser is used for the CentMed campaign without any problem but the tipically script message popping up lately.

Thanks in advance
II/JG77Hawk_5
Posts: 933
Joined: Sun Feb 17, 2008 6:36 am
Location: Central Coast NSW Australia

Post by II/JG77Hawk_5 » Mon Sep 17, 2012 8:35 pm

Excellent!
Welcome to Pelican too Luny!

I don't think that Pelican is fully updated to current version as with Cent Med so that is probably the reason for the load failure.
II/JG77Hawk 5
SEOW fanboy of dubious repute
IV/JG7_4Shades
Posts: 2029
Joined: Sat Jan 26, 2008 3:07 am
Location: Perth, Western Australia

Post by IV/JG7_4Shades » Mon Sep 17, 2012 8:50 pm

Hawk_5, check out the table structure for Pilot_Recon_Reports. Might need the "Key_Mode" field to be added. Compare with CentMed DB. Key_Mode values are 0 for regular Pilot Reports, and 1 for the new Map Annotation reports.

Cheers,
4S
IV/JG7_4Shades
SEOW Developer
II/JG77Hawk_5
Posts: 933
Joined: Sun Feb 17, 2008 6:36 am
Location: Central Coast NSW Australia

Post by II/JG77Hawk_5 » Sun Oct 07, 2012 8:26 am

IV/JG7_4Shades wrote:Hawk_5, check out the table structure for Pilot_Recon_Reports. Might need the "Key_Mode" field to be added. Compare with CentMed DB. Key_Mode values are 0 for regular Pilot Reports, and 1 for the new Map Annotation reports.

Cheers,
4S
Done.
I did this earlier but this post is just to confirm.
II/JG77Hawk 5
SEOW fanboy of dubious repute
Post Reply

Return to “The Pelican Lounge”